listing of electric & manual  machines	on line parts guide for Better Pack® -Phoenix -NPS	on line service guides for Better Pack® - Phoenix

<Back to Service Start Page

Links to Better Packages 333 ® & Phoenix M1 Service

Feed Handle Won't Return

This is a fairly simple problem to correct. Handle Return Spring, M200HRS (Ref FM48AX) is probably broken.

Replacing Handle Return Spring - See Service Figure 2

1. Set machine up right on it's back cover

2. There should be 2 long springs visible. The Rocker Tension Spring - 

    M200CRS (Ref FM33AX) is located closest to left frame. The Handle Return

     Spring  M200HRS (Ref FM48AX) is just to the right of the Rocker Tension Spring. 

3. The Handle Return Spring attaches to the Hammer Cam. 

    This is a black wooden cam located just under the Upper Tape Plate. 

    The Hammer Cam has a small  hole on the piece that protrudes

    The short clip side of the Handle Return Spring goes through this hole.

4  With the spring clipped to the Hammer Cam, run the spring around the 

    silver bar and black wooden roller

5. Clip other end of spring (long clip side) to the middle hole in the Lower Shelf..

Service Figure 1

Handle Return & Crank Return Spring Locations

1- Crank Return Spring - hooks to pin on cutter yoke assembly then goes back to hole in tape basket plate

2- Handle Return Spring - hooks to hole on rocker cam then to lower front cover

If you can't find the answers here, then please feel free to call us at

1-800-899-9389

or

Tigerseal® Products is not affiliated with MCM/Phoenix®

Tigerseal® Products is not affiliated with Better Packages®  Inc.

About Us     Contact Us   Privacy Policy  Legal Notice